3.
Disconnect the clutch switch connector (A).
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Pannel")
IG "OFF"
Disconnect the clutch switch connector (A).
IG "ON"
Measure the voltage between signal terminal of clutch switch harness connector and chassis ground.
Specification : 11.5V ~ 13.0V
Measure the voltage between ground terminal of clutch switch harness connector and chassis ground.
Specification : Continuity ( below 1.0Ω)
Remove the clutch switch.
(Refer to Clutch Switch - "Removal")
Push the clutch switch in the direction of the arrow to make sure that continuity is cut off.
Condition | Clutch Pedal pressed | Clutch Pedal Released |
Switch Operation | ON (below 1.0Ω ) | OFF ( Infinite Ω ) |
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Pannel")
Disconnect the clutch switch connector (A).
Remove the clutch switch (B) by loosening a nut (A).
Install in the reverse order of removal.
Adjust the clutch switch.
Adjust the gab by rotating the adjust nut (A) to satisfy the standard gap range.
Standard gap range:
0.5 ~ 1.0 mm (0.0197 ~ 0.0394 in.)
Tighten the nut (B) with the specified torque.
Tightening torque:
11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)
