3.
Remove the regulator from the connector (C) after removing a pin (B).
The case of diesel vehicle, remove the fuel filter.
D 2.0 (Refer to Engine Control/Fuel System - "Fuel Filter")
D 2.2 (Refer to Engine Control/Fuel System - "Fuel Filter")
Remove the clutch tube (A) from the regulator.
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
Remove the regulator from the connector (C) after removing a pin (B).
Be careful not to enter dust, foreign matters, etc in regulator.
When installing, Apply grease on a O-ring part of regulator connector.
Replace the O-ring with new when install the clutch regulator.
Install in the reverse order of removal.
After be equipped, perform bleeding air procedure in concentric slave cylinder after pouring the brake fluid.
(Refer to Clutch System - "Concentric Slave Cyilnder Assembly")
