4.
Using a GDS, clear the DTC.
Ignition "OFF", connect GDS.
Ignition "ON"& Engine "OFF", select "Diagnostic Trouble Codes(DTC)" mode.
Monitor diagnostic trouble code and present of trouble code.
Using a GDS, clear the DTC.
Is DTC present problem ?
 | ▶ Replace it with a new one and then check if the vehicle specifications are correct. After that, perform SRSCM(ACU) Variant Coding and then, go to "Verification of Vehicle Repair" procedure. |
 | ▶Displaying nothing(no DTC) or DTC with label "H"(historical) shows that Fault is intermittent caused by poor contact in the part's and/or SRSCM connector or was repaired and SRSCM memory was not cleared. ▶Thoroughly check release pin and connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. ▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
