Monitor GDS Data
1.

Ignition "OFF", connect GDS.

2.

Ignition "ON"& Engine "OFF", select "Current Data" mode.

3.

Monitor the "All airbag resistance" parameter on the GDS.

Specification : 1.6Ω＜ Resistance of airbag ＜ 6Ω

Reference : In a case of an open in the airbag circuit : FAIL

In a case of a short to battery in the airbag circuit: FAIL

In a case of a short to ground in the airbag circuit : FAIL

Fig.1) Normal Data

4.

Is parameter displayed within specifications?

▶ Displaying nothing(no DTC) or DTC with label "H"(historical) shows that Fault is intermittent caused by poor contact in the part’s and/or SRSCM connector or was repaired and SRSCM memory was not cleared.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

▶ Check for short between ignition circuits of DAB,PAB,BPT,CAB,SAB,APT. If the condition of harness and component is OK, this fault is caused by SRSCM internal error so replace a known-good SRSCM and then go to "Verification of vehicle Repair" procedure.

Яндекс.Метрика