4.
Engine speed up to about 2000rpm and check Input speed(PG-A)&Output speed(PG-B) are within specific at 1st speed of gear.
Specification : Output speed<(input speed-200rpm)/1st. gear ratio
Connect scantool to Data Link Connector(DLC).
Ignition "ON" & Engine "ON".
Select "Current Data" mode and monitor "Engine speed, Input speed sensor(PG-A), Output speed sensor(PG-B) and Gear position" parameter used select option.
Engine speed up to about 2000rpm and check Input speed(PG-A)&Output speed(PG-B) are within specific at 1st speed of gear.
Specification : Output speed<(input speed-200rpm)/1st. gear ratio
Are measured Input speed(PG-A)&Output speed(PG-B) within specifiction?
 | ▶ Go to "Component Inspection" procedure. |
 | ▶ Check there are electrical nosie at Inout/output speed and Repair as necessary and go to "Verification Vehicle Repair" procedure. |
