Connect GDS to Data Link Connector(DLC).

Ignition "ON" & Engine "ON".

Driving 1st speed to 6th speed at D-range.

Select "Current Data" mode and monitor "Torque converter clutch" parameter.

Fig 1) "P,N" range

Fig 2) "R" range

Fig 3) "D" range 1st gear

Fig 4) "D" range 2nd gear

Fig 5) "D" range 3rd gear

Fig 6) "D" range 4th gear

Fig 7) "D" range 5th gear

Fig 8) "D" range 6th gear

Is Torque conveter clutch value within specification?

	▶ Fault is intermittent caused by poor contact of TCM & sencor and DTC was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair as necessary and go to "Verification Vehicle Repair" procedure.
	▶ Go to "Component Inspection" procedure.