3.
Select "Current Data" mode and monitor "Oil temperature sensor" parameter.
Specification : Increasing Gradually
Fig 1) Normal Data
Fig 2) Open Data
Connect GDS to Data Link Connector(DLC).
Ignition "ON" & Engine "ON".
Select "Current Data" mode and monitor "Oil temperature sensor" parameter.
Specification : Increasing Gradually
Fig 1) Normal Data
Fig 2) Open Data
Is the Oil temperature sensor within specification?
 | ▶ Fault is intermittent caused by poor contact of TCM and DTC was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair as necessary and go to "Verification Vehicle Repair" procedure. |
 | ▶ Go to "Terminal and Connector Inspection" procedure. |
