Component Inspection
■ Clutch Switch Check
1.

IG OFF.

2.

Disconnect the clutch switch connector.

3.

Measure resistance between ground terminal and signal terminal of the clutch switch connector.

Specification :

Approx. below 1Ω (In case of pressing the clutch switch)

Approx. ∞ Ω (In case of not pressing the clutch switch)

4.

Is the measured value within specifications ?

▶ Fault is intermittent caused by poor connection in clutch switch harness and/or HECU's connector.

▶ Substitute with a known-good clutch switch and check for proper operation. If problem is corrected, replace clutch switch and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика