PCM/ECM sets DTC P2128 if the PCM/ECM detects output voltage higher than the possible range of a properly operating APS2.
Item | Detecting Condition | Possible Cause |
DTC Strategy |
•
Electrical Check | 1. Open in ground circuit 2. Short to battery in signal circuit 3. Poor connection or damaged harness 4. Faulty APS2 |
Enable Conditions |
•
No error for power supply circuit in APS2 | |
Threshold Value |
•
APS2 > 2.5V | |
Diagnostic Time |
•
0.3 sec. | |
MIL On Condition |
•
1 driving cycle | |
Limp-Home |
•
Forced limited power mode : The PCM/ECM limits opening angle of the throttle valve to max. 50% and engine torque to a certain pre-determined value.
•
After idle recognition, the PCM/ECM uses APS2 signal to calculate the current opening angle of the throttle valve. |
