4.
Any change in the values indicates a poor connection. Was a connector problem found?
 | ▶ Repair the connector. Go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "Signal Circuit Inspection" procedure. |
Disconnect the HO2S(s) and PCM/ECM connectors and inspect for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Reconnect the connectors.
Connect the GDS and go to “Current Data”.
Monitor HO2S(s) values in Current Data, check and wiggle the harness(es), connector(s), and terminal(s).
Any change in the values indicates a poor connection. Was a connector problem found?
| ▶ Repair the connector. Go to "Verification of Vehicle Repair" procedure. |
| ▶ Go to "Signal Circuit Inspection" procedure. |
Disconnect the HO2S(s) and PCM/ECM connectors and inspect for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Reconnect the connectors.
Connect the GDS and go to “Current Data”.
Monitor HO2S(s) values in Current Data, check and wiggle the harness(es), connector(s), and terminal(s).
Any change in the values indicates a poor connection. Was a connector problem found?
| ▶ Repair the connector. Go to "Verification of Vehicle Repair" procedure. |
| ▶ Go to "Control Circuit Inspection" procedure. |
IG "OFF". Disconnect PCM/ECM and HO2S connector
IG "ON".
Measure voltage between signal terminal of HO2S(B1S1) harness connector and chassis ground.
Specification : Approx. 0.4~0.5V
Is voltage within the specification?
| ▶ Go to next step as below. |
| ▶ Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure. |
HO2S must have a clean air reference to function properly. The air is obtained by way of the sensor wire(s). Do not attempt to repair the wire(s), connector, or the terminals.
IG "OFF". Disconnect HO2S connector.
IG "ON".
Measure voltage between VN terminal of the sensor harness connector and chassis ground.
Measure voltage between VG terminal of the sensor harness connector and chassis ground.
Measure voltage between VRC terminal of the sensor harness connector and chassis ground.
Measure voltage between VIP terminal of the sensor harness connector and chassis ground.
Specification : Approx. 2~3V
Is HO2S display near the specification?
| ▶ Go to next step as below. |
| ▶ Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure. |
HO2S must have a clean air reference to function properly. The air is obtained by way of the sensor wire(s). Do not attempt to repair the wire(s), connector, or the terminals.
