2.
Select 'Actuation Test' mode and execute 'ETC motor' item.
Specification :
▶ During 'ETC Motor' test, TPS1 and TPS2 show symmetrical movements.
IG "ON"
Select 'Actuation Test' mode and execute 'ETC motor' item.
▶ During 'ETC Motor' test, TPS1 and TPS2 show symmetrical movements.
Is the waveform normal?
 | ▶ Check for poor connection between PCM/ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
 | ▶ Check ETC for contamination, deterioration, or damage. Substitute with a known-good ETC and check for proper operation. If the problem is corrected, replace TPS and then go to "Verification of Vehicle Repair" procedure. |
It is necessary to perform the TPS adaptation procedure after the ETC assembly or PCM/ECM replacing.
■ TPS adaptation procedure
Ignition "OFF" and then "ON" without cranking. Wait for 10 seconds under enable conditions.
→ Enable conditions : Battery 〉10V ＆ Intake Air Temp. 〉5.3℃(41.5℉) ＆ 5.3℃(41.5℉) 〈Engine CoolantTemp. 〈99.8℃(211.6℉)
