Disconnect the APS and PCM/ECM connectors and inspect for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Reconnect the connectors.

Connect the GDS and go to “Current Data”.

Monitor APS values in Current Data, check and wiggle the harness(es), connector(s), and terminal(s).

Any change in the values indicates a poor connection. Was a connector problem found?

	▶ Repair the connector. Go to "Verification of Vehicle Repair" procedure.
	▶ Go to "Power Circuit Inspection" procedure.

IG "OFF".

Disconnect APS harness connector.

IG "ON"

Measure voltage between APS2 power terminal of APS harness connector and chassis ground.

Is the measured voltage within specification ?

	▶ Go to next procedure.
	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.