Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

	▶ Repair as necessary and go to "Verification of vehicle Repair" procedure.
	▶ Go to " Signal Circuit Inspection " procedure.

IG KEY "OFF".

Disconnect HO2S(S1) connector.

IG KEY "ON" & ENG "OFF"

Measure the voltage between Virtual Ground Output terminal of HO2S(S1) harness connector and chassis ground.

Measure the voltage between Nernst Voltage terminal of HO2S(S1) harness connector and chassis ground.

Measure the voltage between Current Pump terminal of HO2S(S1) harness connector and chassis ground.

Measure the voltage between Current Adjust terminal of HO2S(S1) harness connector and chassis ground.

Is the measured voltage within specification ?

	▶ Go to "Component Inspection" procedure.
	▶ Repair Open or Short circuit and then, go to "Verification of Vehicle Repair" procedure.