1.
Using a screwdriver or remover, remove the center garnish [LH] (A).
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Using a screwdriver or remover, remove the center garnish [LH] (A).
After loosening the mounting screw, then remove the center fascia panel (A).
Disconnect the hazard switch connector (A).
Install in the reverse order of removal.
Make sure the connector are connected in properly.
Replace any damaged clips.
