2.
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
[LH,RH]
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
[Center]
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Remove the rear wheel house trim.
(Refer to Interior Trim - "Rear Wheel House Trim")
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
[LH,RH]
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
[Center]
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
Disconnect the high Mounted stop lamp (A) connecter from inside the trunk.
Remove the rear seat belt upper anchor cover (A).
Using a screwdriver or remover, remove the rear package tray trim (A).
Install in the reverse order of removal.
Make sure the connector is plugged in properly.
Replace any damaged clips.
