2.
Disconnect the rear seat heater control unit connector (A).
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
Disconnect the rear seat heater control unit connector (A).
After removing the hog-ring clips (A) on the rear of seat cushion and remove the rear seat cushion cover (B).
[Rear side]
[Front side]
Install in the reverse order of removal.
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).
