1.
Install the control cable (B) and clip (A) on the bracket.
When installing, set room side Shift lever and T/M side lever to N position.
Install the control cable (B) and clip (A) on the bracket.
Install the washer (B) and pin (A).
Tighten the nut (B) after install the retainer (A).
Tightening torque:
11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)
Install the cable socket (A) on the shift lever assembly.
Install the shift cable (B) and clip (A).
Shift lever to "3rd".
Install the snap pin (A) after install the select cable (B).
Install the snap pin (A) after adjust the select cable (B).
(Refer to Control Cable - "Adjustment")
Install the floor console assembly.
(Refer to Body - " Floor Console")
Install the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Install the air cleaner assembly.
(Refer to Engine Electrical System - "Battery")
