1.
Check for continuity between teh trunk lid open switch terminal.
Refer to Smart key System - "Smart key Diagnostic"
Refer to Smart key System - "Smart key Diagnostic"
Refer to Smart key System - "Smart key Diagnostic"
Check for continuity between teh trunk lid open switch terminal.
If continuity is not specified, inspect the switch.
Disconnect the negative (-) battery terminal.
Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
Remove the RF receiver (A) after loosening a nut.
Disconnect the SMK connectors (A) from the SMK unit.
Remove the smart key unit (A) with loosening the nut and screw.
Take care not to scratch the crash pad and related parts.
Disconnect the negative(-) battery terminal.
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly")
Disconnect the connector, then remove the interior antenna (A) with loosening 2 nuts.
Disconnect the negative(-) battery terminal.
Using a clip remover, detach the clips, and remove the rear transverse trim (A).
Disconnect the connector, then remove the trunk antenna (A) with loosening 2 nuts.
Disconnect the negative(-) battery terminal.
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
Disconnect the connector, then remove the rear bumper antenna (A) with loosening 2 screws.
Disconnect the negative(-) battery terminal.
Remove the front left wheel guard.
Remove the buzzer (B) after disconnecting the connector (A).
Disconnect the negative (-) battery terminal.
Remove the front door module.
(Refer to Front Door - "Front Door Module")
Disconnect the front door outside handle connector (A).
Remove the hole plug (A).
After loosening the mounting bolt, then remove the front door outside handle cover (B).
Remove the front door outside handle (A) by sliding it rearward.
Disconnect the negative (-) battery terminal.
Remove the trunk lid trim.
(Refer to Body - "Trunk Lid Trim")
Disconnect the trunk lid open switch connector (A).
Remove the trunk outside handle (B) after pressing the clips (A).
Install the smart key unit and RF receiver.
Connect the connector and install the smart key unit.
Install the main crash pad assembly.
Install the negative (-) battery terminal and check the smart key system.
Install the interior antenna.
Install the floor console assembly.
Install the negative (-) battery terminal and check the smart key system.
Install the trunk antenna.
Install the rear transverse trim.
Install the negative (-) battery terminal and check the smart key system.
Install the exterior bumper antenna.
Install the rear bumper cover.
Install the negative (-) battery terminal and check the smart key system.
Install the buzzer.
Install the front left wheel guard.
Install the negative (-) battery terminal and check the smart key system.
Install the door outside handle.
Install the door trim.
Install the negative (-) battery terminal and check the smart key system.
Install the trunk lid open switch.
Install the trunk trim.
Install the negative (-) battery terminal and check the smart key system.
