5.
Disconnect the light switch connector (A) and the wiper switch connector (B).
[LHD]
[RHD]
[LHD]
[RHD]
Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch.
Disconnect the negative (-) battery terminal.
Remove the steering wheel.
(Refer to Steering System - "Steering Wheel")
Remove the steering column upper and lower shrouds.
(Refer to Body - "Steering Column Shroud Panel")
Remove the clock spring.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
Disconnect the light switch connector (A) and the wiper switch connector (B).
Remove the wiper switch (A) by pushing the lock pin (B).
When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.
Loosen the screws (2EA) from the multifunction switch assembly (A).
Install the multifunction switch.
Install the clock spring.
Install the steering column upper and lower shrouds.
Install the steering wheel.
Make sure the multifunction switch connectors are plugged in properly.
