2.
Disconnect the TCM connector (A).
When replacing the Transaxle Control Module (TCM), the vehicle equipped with immobilizer must be performed the procedure as below.
[In the case of installing used TCM]
Perform "TCM neutralization mode" procedure with GDS.
(Refer to Body Electrical System-"Immobilizer")
Insert the key and turn it to the IGN ON and OFF position.
Then the TCM key register process is completed automatically.
[In the case of installing new TCM]– Insert the key and turn it to the IGN ON and OFF position.
Then the TCM key register process is completed automatically.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Disconnect the TCM connector (A).
Remove the bracket installation bolts (A) and the nut (B).
TCM installation bolt/nut :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
