2.
Remove the circlip (B) from the driveshaft spline (A).
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
The boot band should be replaced with a new one.
Remove the Front Driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
Remove the circlip (B) from the driveshaft spline (A).
Remove both boot bands from the TJ case.
Remove the TJ case (A).
Make alignment marks on spider roller assembly (A), joint case (B), and shaft spline (C) to aid reassembly.
Remove the snap ring (A) from the shaft.
Remove the spider assembly (B) from the driveshaft (A) using the special tool (09495-33000).
Clean the spider assembly.
Remove the TJ boot (A).
For reusing the boot (A), wrap tape (B) around the driveshaft splines (C) to protect the boot (A).
