3.
Disconnect the ETC module connector (A).
Connect the GDS on the Data Link Connector (DLC).
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle Angle | Output Voltage (V) | |
TPS 1 | TPS 2 | |
C.T | 0.5 | 4.5 |
W.O.T | 4.41 | 0.59 |
Turn the ignition switch OFF.
Disconnect the ETC module connector.
Measure resistance between the ETC module terminals 1 and 2.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the resonator and the air intake hose. (Refer to Engine Mechanical System - “Air Cleaner”)
Disconnect the ETC module connector (A).
Disconnect the coolant hoses (B).
Remove the installation bolts (C), and then remove the ETC module from the engine.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Install in the reverse order of removal.
Electronic throttle body Installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
