3.
Disconnect the fuel feed tube (A) after remove the nuts (B).
Turn the ignition switch OFF, and then remove battery (-) cable.
Release the residual pressure in fuel line. (Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
Disconnect the fuel feed tube (A) after remove the nuts (B).
Disconnect the vapor hose (A) which is connected from the PCSV.
Remove the fuel tank. (Refer to Fuel Delivery System - " Fuel Tank")
Open the vapor tube and low fuel line fixing clip (A) using driver.
Open the vapor tube line fixing clip (A) using driver.
Remove the installation nuts, and then push the heat protect in the direction.
Disconnect the fuel feed line fixing clip (A) from engine room lower.
Disconnect the fuel & brake line protect (A) from the fixing clip.
Remove the fuel line (A).
Do not use already used injector fixing clip again.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Install in the reverse order of removal.
