2.
Check sensor data as below.
IG key ON.
Check sensor data as below.
Data Analysis
Condition | GDS Sensor Data | ||
APS 1 | APS 2 | ||
IG Key "ON & Engine "OFF" | Output voltages of APS1 and APS2 are in proportion to accelerating. APS2 output voltage is half of APS1 output voltage. | ||
Release a pedal fully | 0.58~0.93V | 0.29~0.47 | |
Depress a pedal fully | 3.85~4.35V | 1.93~2.18V | |
Is data in accordance with "Data Anaysis"?
 | ▶ Check for poor connection between PCM/ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
 | ▶ Substitute with a known-good component and check for proper operation. If the problem is corrected, replace component and then go to "Verification of Vehicle Repair" procedure. |
