Monitor GDS Data
1.

Connect GDS to DLC(Data Link Connector)

2.

IG "ON". Check if any other Diagnostic Trouble Codes (DTC) are set.(There will be at least one more DTC which causes this DTC P2105 to set)

3.

Repair the other DTCs first that caused DTC P2105 to set. Review the appropriate trouble shooting guide. After repairing the DTCs that caused DTC P2105, Do "Procedure of ETC Initialization".

4.

Is the same DTC occurred ?

▶ Fault is intermittent, caused by poor contact in the sensor's and/or PCM/ECM's connector or was repaired and PCM/ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure.

▶ Go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика