7099123

1.

Connect GDS to Data Link Connector(DLC).

2.

Warm up the engine to normal operating temperature.

3.

Monitor TPS related parameter on the "Current Data" with GDS.

Fig.1) Check the change under the condition of acceleration and deceleration.

Fig.2) Check the 'TPS' and 'APS' under idle state.

4.

Are the parameters displayed correctly ?

	▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECM/PCM’s connector or was repaired and ECM/PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.
	▶Go to "Terminal and Connector Inspection" procedure.