7099730

1.

IG "OFF".

2.

Disconnect OCV connector.

3.

Measure resistance between terminal 1 and 2 of OCV connector.(Component Side)

Specification :

ITEM	Specification
Coil Resistance (Ω)	6.9 ~ 7.9 [20 ℃ 68 ℉]

4.

Connect GDS to Data Link Connector(DLC)

5.

IG Key "ON" & ENG "OFF"

6.

Perform "Oil Control Valve - Intake Bank1" in the "Actuation Test" with GDS.

7.

Does the OCV work normally? (Check clicking sound)

	▶ Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage. So, check poor connections and the related circuit between ECM/PCM and component thoroughly. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
	▶ Substitute with a known - good OCV and check for proper operation. If the problem is corrected, replace OCV and go to "Verification of Vehicle Repair" procedure.