Component Inspection
■ Check VIS
1.

IG "OFF" and disconnect VIS connector.

2.

Measure resistance between power and control terminals of VIS connector.(Component side)

Specification : 30 ~ 35 Ω (22℃/71.6℉)

3.

Is the measured resistance within specification ?

▶ Substitute with a known - good ECM/PCM and check for proper operation. If the problem is corrected, replace ECM/PCM and go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known - good VIS and check for proper operation. If the problem is corrected, replace VIS and go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика