3.
Select "Diagnostic Trouble Codes(DTC)" Analysis and press "DTC Status".
Connect GDS to DLC(Data Link Cable).
IG "ON".
Select "Diagnostic Trouble Codes(DTC)" Analysis and press "DTC Status".
Is the parameter displayed "Present"?
 | ▶ Go to "Monitor GDS Data". |
 | ▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECM’s connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure. |
Connect GDS to DLC(Data Link Cable).
Check the "Current Data" about related DTC with GDS.
Fig.1) IG On & Engine Off(Cold condition)
Fig.2) Engine Idle after Warm Up
Are the parameters displayed correctly ?
| ▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECM’s connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure. |
| ▶ Go to "Terminal & Connector Inspection" procedure. |
