7101679

Component Inspection

■ Check PCSV

Connect GDS to Data Link Connector(DLC).

IG KEY "ON" & ENG "OFF".

Perform "Actuation Test" for PCSV.

IG Key "OFF".

Disconnect PCSV connector.

Measure resistance between power and control terminal of the PCSV. (Component Side)

Specification : Approx. 24 ± 2 [20°C(68 °F)]

	▶ Go to "Check injector for normal operation" as follows.
	▶ Replace it, and go to "Verification of Vehicle Repair" procedure.

■ Check injector for normal operation

Connect GDS to Data Link Connector(DLC).

Perform "Actuation Test" for Injector.

Check its RPM decrease when doing the injector's actuation test.

10.

Is there any cylinder with no change in RPM or only a small change in RPM?

	▶ Replace injector, and go to "Verification of Vehicle Repair" procedure.
	▶ Go to "Verification of Vehicle Repair" procedure.