Monitor DTC Status
1.

Connect GDS to DLC(Data Link Cable).

2.

Select "Electronic Stability Program".

3.

3. Check the "Current Data" regarding wheel speed sensor with GDS.

4.

Is the parameter displayed "Present"?

▶ Go to "Monitor GDS Data".

▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECM’s connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.

Monitor GDS Data
1.

Connect GDS to DLC(Data Link Cable).

2.

Select "Electronic Stability Program" and perform to inspect regarding wheel speed sensor with GDS

Fig.1) ESP System - "D Range" at idle

3.

Select "Engine Control" and perform to inspect regarding wheel speed sensor with GDS

4.

Check the "Current Data" about related DTC with GDS.

Fig.2) Engine System - "D Range" at idle

5.

Are the parameters displayed correctly?

▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECM’s connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.

▶ Go to "Terminal and Connector inspection" procedure.

Яндекс.Метрика