3.
Select "Current Data" mode and monitor "Evaporator sensor" parameter.
Fig.1) Parameter of "Evaporator Sensor" will be fixed at -2℃(28.4℉), if there is any fault in Evaporator Sensor.
Connect GDS with diagnostic connector.
Warm up the engine to normal engine temperature after engine starts.
Select "Current Data" mode and monitor "Evaporator sensor" parameter.
Fig.1) Parameter of "Evaporator Sensor" will be fixed at -2℃(28.4℉), if there is any fault in Evaporator Sensor.
Is the Evaporator Sensor abnormal ?
 | ▶ Go to "Inspection and Repair" procedure. |
 | ▶ This is a intermittent problem caused by poor contact of component or Control Module. ▶ Thoroughly check the looseness, poor connection, bent, corrison, contamination, deformation or damage of connector. ▶ Repair or replace as necessary and then, go to "Verification of Vehicle Repair" procedure. |
