Many malfunctions in the electrical system are caused by poor connection. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration,or damage.

Has a problem been found?

	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.
	▶ Go to "W/Harness Inspection" procedure.

Ignition "OFF"

Disconnect Incar temp.sensor and A/C control Module main harness connector.

Measure resistance between Signal(+) terminal of incar temp.sensor harness connector and chassis ground

Is the measured resistance within specification?

	▶ Go to " Component inspection " procedure .
	▶ Check for short to ground in harness. ▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure.