1.
Disconnect the cruise control switch connector from the control switch.
Disconnect the cruise control switch connector from the control switch.
Measure the resistance between the terminals below when the function switch is ON.
Function switch | Connector terminal | Resistance (±5%) |
CANCEL | 2-7 | 180 Ω |
SET- | 2-7 | 330 Ω |
RES+ | 2-7 | 550 Ω |
CRUISE | 2-7 | 880 Ω |
Flex steer | 2-7 | 5.54 kΩ |
If the measured value is not within the specification, replace the switch.
Connect the cruise control switch connector to the control switch.
Measure the voltage between the terminals below when the function switch is ON.
Function switch | Connector terminal | Voltage (V) |
CANCEL | 2-7 | 0.6 ~ 0.9 |
SET- | 2-7 | 1.04 ~ 1.44 |
RES+ | 2-7 | 1.55 ~ 1.99 |
CRUISE | 2-7 | 2.24 ~ 2.44 |
Flex steer | 2-7 | 4.01 ~ 4.47 |
If the measured value is not within specification, inspect the control switch resistance.
Disconnect the negative (-) battery terminal.
Remove the driver airbag module.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
Remove the steering wheel.
(Refer to Steering System - "Steering Column and Shaft")
Remove the steering wheel cover (A) after loosening the screw.
Disconnect the steering heater connectors (A).
Remove the steering remote control switch assembly after loosening the mounting screws (4EA).
Disconnect the switch connectors (A).
Remove the cruise control switch (A) after loosening the mounting screws.
Reassemble the cruise control switch after connecting the connector.
Reassemble the driver airbag module.
Make sure the audio remote control switch and the airbag module connectors are plugged in properly.
