3.
Remove the RF receiver (A) after loosening a nut.
Disconnect the negative (-) battery terminal.
Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
Remove the RF receiver (A) after loosening a nut.
Disconnect the SMK connectors (A) from the SMK unit.
Remove the smart key unit (A) with loosening the nut and screw.
Take care not to scratch the crash pad and related parts.
Disconnect the negative(-) battery terminal.
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly")
Disconnect the connector, then remove the interior antenna (A) with loosening 2 nuts.
Disconnect the negative(-) battery terminal.
Using a clip remover, detach the clips, and remove the rear transverse trim (A).
Disconnect the connector, then remove the trunk antenna (A) with loosening 2 nuts.
Disconnect the negative(-) battery terminal.
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
Disconnect the connector, then remove the rear bumper antenna (A) with loosening 2 screws.
Disconnect the negative(-) battery terminal.
Remove the front left wheel guard.
Remove the buzzer (B) after disconnecting the connector (A).
Disconnect the negative (-) battery terminal.
Remove the front door module.
(Refer to Front Door - "Front Door Module")
Disconnect the front door outside handle connector (A).
Remove the hole plug (A).
After loosening the mounting bolt, then remove the front door outside handle cover (B).
Remove the front door outside handle (A) by sliding it rearward.
Disconnect the negative (-) battery terminal.
Remove the trunk lid trim.
(Refer to Body - "Trunk Lid Trim")
Disconnect the trunk lid open switch connector (A).
Remove the trunk outside handle (B) after pressing the clips (A).
