Remove the connector from the rear wiper motor.
Connect battery positive (+) and negative (-) cables to terminals 4 and 3(wiper motor bracket) respectively.
Check that the motor operates normally. Replace the motor if it operates abnormally.
Sparks can be happen when connecting wiper motor bracket(no.3 ground) with the status that the battery (+) terminal is connected.
No. | Description |
1 | Battery (+) |
2 | Parking |
3 | Ground |
4 | Start |
When the rear wiper motor is on inspection, the motor assembly can move. So fix the motor assembly surely.
The operator should be insulated when connecting the terminals. (Using the flat driver with knob, connect the terminal 2 and 4.)
Be careful not to change the order(no.4 and no.5).
Remove the rear wiper motor assembly.
(Refer to Body Electrical - "Rear Wiper Motor")
Mark the blade set position (A) before removing the rear wiper motor.
Connect the positive (+) lead from the battery to terminal 4 and the negative (-) lead to terminal 3.
Disconnct the positive (+) lead from the battery to terminal 4 except the rear wiper blade set position.
Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 3. (With the status that the rear wiper motor does not work.)
Check that the motor moves to auto stop position by connecting the terminal 2 and 4.
Detach the rear wiper cap (A).
Remove the rear wiper arm ＆ blade (B) after removing rear wiper HEX nut (A).
Remove the rear wiper cap & pad (A).
Remove the tailgate trim after opening the tailgate.
(Refer to Body - "Tailgate Trim")
Disconnect the rear wiper motor connector (A) then remove the rear wiper motor (B) after loosening bolts.
Install the rear wiper motor assembly.
Tightening torque Nut :
6.9~9.8 Nm (0.7~1.0 kgf.m, 5.0~7.2 lbf.ft)
Install the tailgate trim.
Install the rear wiper arm cap after tighting the nut.
Tightening torque Bolt :
3.9~6.9 N.m (0.4~0.7 kgf.m, 2.9~5.1 lbf.ft)
Set the rear wiper blade and to the lowest defogger heat line and tailgate glass.
A : Auto stop position
