3.
Removal the water temperature control assembly (B).
Turn ignition switch OFF.
Disconnect ECTS connector.
Remove the ECTS.
After immersing the thermistor of the sensor into engine coolant, measure resistance between ECTS terminals 1 and 3.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the engine coolant temperature sensor connector (A).
Removal the water temperature control assembly (B).
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped.
Apply the engine coolant to the O-ring.
Insert the sensor in the installation hole and be careful not to damage.
Install in the reverse order of removal.
Engine coolant temperature sensor installation:
29.4 ~ 39.2 N.m (3.0 ~ 4.0 kgf.m, 21.7 ~ 28.9 lb-ft)
