3.
Remove the installation bolt (B), and then remove the crankshaft position sensor.
Check signal waveform of CKPS and CMPS using a GDS.
Specification: Refer to “Waveform”
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the crankshaft position sensor connector (A).
Remove the installation bolt (B), and then remove the crankshaft position sensor.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Apply the engine oil to the O-ring.
Insert the sensor in the installation hole and be careful not to damage when installation.
Be careful not to damage the sensor housing and the connector.
Be careful not to damage the O-ring.
Install in the reverse order of removal.
Crankshaft position sensor installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
