5.
Disconnect the inhibitor switch connector (A).
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Disconnect the Inhibitor swtich connector.
Ignition KEY "ON"" & Engine "OFF".
Measure voltge between supplied power and ground at inhibitor circuit.
Specification : Approx. 12V
Connect the Inhibitor switch connector.
Ignition KEY "ON" & Engine "OFF".
Measure voltages between each terminal and chassis ground during shift lever changed "P, R, N, D".
Specification : See below "Signal Code Table"
| P | P-R | R | R-N | N | N-D | D |
Signal "1" | 12V | 12V | 0 | 0 | 0 | 0 | 0 |
Signal "2" | 0 | 12V | 12V | 12V | 0 | 0 | 0 |
Signal "3" | 0 | 0 | 0 | 12V | 12V | 12V | 0 |
Signal "4" | 0 | 0 | 0 | 0 | 0 | 12V | 12V |
Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
Disconnect the negative (-) battery cable.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
Remove the shift cable mounting nut (B).
Disconnect the inhibitor switch connector (A).
Remove the manual control lever (B) and the washer after removing a nut (A).
Remove the inhibitor assembly (A) after removing the bolts (2ea).
Install the inhibitor switch (A).
When installing, tighten the inhibitor assembly mounting bolts lightly, so that necessary adjustments can be made.
Install the manual lever (A) after fixing the "N" jig hole (B) using the SST(09480-A3800) or 0.1969in.(5mm) bolt.
Tightening torque :
16.7 ~ 20.6 N.m (1.7 ~ 2.1 kgf.m, 12.3 ~ 15.2 lb-ft)
Tighten the bolts (C) to specifications.
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Remove the SST(09480-A3800) or 0.1969in.( 5mm) bolt.
Connect the inhibitor switch connector (A) and then tighten the nut (B).
Tightening torque:
9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)
Adjust the shift cable before tighten the nut.
(Refer to Automatic Transaxle Control System - "Shift lever")
Install the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
Connect the negative (-) battery cable.
