1.
Install the inhibitor switch (A).
note
When installing, tighten the inhibitor assembly mounting bolts lightly, so that necessary adjustments can be made.
Install the inhibitor switch (A).
When installing, tighten the inhibitor assembly mounting bolts lightly, so that necessary adjustments can be made.
Install the manual lever (A) after fixing the "N" jig hole (B) using the SST(09480-A3800) or 0.1969in.(5mm) bolt.
Tightening torque :
16.7 ~ 20.6 N.m (1.7 ~ 2.1 kgf.m, 12.3 ~ 15.2 lb-ft)
Tighten the bolts (C) to specifications.
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Remove the SST(09480-A3800) or 0.1969in.( 5mm) bolt.
Connect the inhibitor switch connector (A) and then tighten the nut (B).
Tightening torque:
9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)
Adjust the shift cable before tighten the nut.
(Refer to Automatic Transaxle Control System - "Shift lever")
Install the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
Connect the negative (-) battery cable.
