1.
Separate the push rod (C) after remove the pin (A) and washer (B).
Separate the push rod (C) after remove the pin (A) and washer (B).
Remove the battery.
G 1.6 MPI (Refer to Engine Electrical System - "Battery")
F 1.6 MPI (Refer to Engine Electrical System - "Battery")
G 2.0 MPI (Refer to Engine Electrical System - "Battery")
Remove the ECM.
G 1.6 MPI (Refer to Engine Control/Fuel System - "Engine Control Module (ECM)")
F 1.6 MPI (Refer to Engine Control/Fuel System - "Engine Control Module (ECM)")
G 2.0 MPI (Refer to Engine Control/Fuel System - "Engine Control Module (ECM)")
Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
In case of gasoline 2.0, remove the tube with regulator.
Remove the master cylinder (A) by rotating in a clockwise direction.
