Inspection
Component Inspection
1.

Remove the clutch switch.

(Refer to Clutch Switch - "Removal")

2.

Push the clutch switch in the direction of the arrow to make sure that continuity is cut off.

caution

Condition

Clutch Pedal pressed

Clutch Pedal Released

Switch Operation

ON (below 1.0Ω )

OFF ( Infinite Ω )

Removal
1.

Turn ignition switch OFF and disconnect the negative (-) battery cable.

2.

Remove the smart junction box

(Refer to Body Electrical System - "Relay Box (Passenger Compartment)")

3.

Disconnect clutch switch connector (A).

4.

Remove the clutch switch (B) by loosening a nut (A).

Installation
1.

Install in the reverse order of removal.

2.

Adjust the clutch switch.

(1)

Adjust the gab by rotating the adjust nut (A) to satisfy the standard gap range.

Standard gap range:

0.5 ~ 1.0 mm (0.0197 ~ 0.0394 in.)

(2)

Tighten the nut (B) with the specified torque.

Tightening torque:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Яндекс.Метрика