1.
Drill out all spotwelds attaching the fender apron upper outer member.
note
When spotwelded portions are not apparent, remove paint with a rotary wire brush.
Drill out all spotwelds attaching the fender apron upper outer member.
When spotwelded portions are not apparent, remove paint with a rotary wire brush.
Measure and mark the cutline on the fender apron upper reinforcement. Cut the fender apron upper reinforcement along the cutline.
Remove the fender apron upper member and fender apron upper reinforcement.
Prepare all surfaces to be welded.
After removing, apply the welding primer.
Measure and mark the cutline on the new fender apron upper reinforcement. Cut the new fender apron upper reinforcement along the cutline.
Drill the holes in the flange of the replacement new fender apron upper reinforcement for MIG plug welding.
Fit and clamp the new fender apron upper reinforcement in place.
Measure each measurement point (Refer to the Body Dimensions) and correct the installation position.
MIG plug weld all holes and MIG butt weld the seam.
Clean and prepare all welds, and remove all residues.
Apply an anti-corrosion agent as required (Refer to the Body Corrosion Protection).
Prepare the exterior surfaces for priming using wax and grease remover.
Apply the correct seam sealer to all joints carefully (Refer to the Body Sealing Location).
