1.
Drill out all spotwelds and MIG plug welds, and grind away MIG lap weld attaching the fender apron panel assembly.
note
When spotwelded portions are not apparent, remove paint with a rotary wire brush.
Drill out all spotwelds and MIG plug welds, and grind away MIG lap weld attaching the fender apron panel assembly.
When spotwelded portions are not apparent, remove paint with a rotary wire brush.
Remove the fender apron panel assembly.
Prepare all surfaces to be welded.
After removing, apply the welding primer.
Drill the holes in the flange of the replacement new fender apron panel assembly for MIG plug welding.
Fit and clamp the new fender apron panel assembly in place.
Measure each measurement point (Refer to the Body Dimensions) and correct the installation position.
MIG plug weld all holes and MIG lap weld the seams.
Clean and prepare all welds, and remove all residues.
Apply an anti-corrosion agent as required (Refer to the Corrosion Protection).
Prepare the exterior surfaces for priming using wax and grease remover.
Apply the correct seam sealer to all joints carefully (Refer to the Body Sealing Location).
