Disconnect the A/C Pressure Sensor and PCM/ECM connectors and inspect for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Reconnect the connectors.

Connect the GDS and go to “Current Data”.

Monitor A/C Pressure Sensor values in Current Data, check and wiggle the harness(es), connector(s), and terminal(s).

Any change in the values indicates a poor connection. Was a connector problem found?

	▶ Repair the connector. Go to "Verification of Vehicle Repair" procedure.
	▶ Go to "Power Circuit Inspection" procedure.

IG "OFF".

Disconnect APT connector.

IG "ON".

Measure voltage between power terminal of APT harness connector and chassis ground.

Is the measured voltage within specification ?

	▶ Go to next procedure.
	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.