7071683

1.

IG "ON" and select 'Oscilloscope' menu in GDS.

2.

Connect probe to signal line of clutch switch.

3.

Measure voltage with stepping on and off the clutch pedal.

Specification :

Test Condition	With releasing pedal	With stepping on pedal
Voltage	12 V	0 V

4.

Is the measured voltage within specification ?

	▶ Check for poor connection between PCM/ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
	▶ Check the component for contamination, deterioration, or damage. Substitute with a known-good component and check for proper operation. If the problem is corrected, replace the component and then go to "Verification of Vehicle Repair" procedure.