Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

	▶ Repair as necessary and go to "Verification of vehicle Repair" procedure.
	▶ Go to "Power Circuit Inspection" procedure.

IG "OFF"

Disconnect APS connector.

IG "ON" & ENG "OFF".

Measure the voltage between APS2 power terminal of APS harness connector and chassis ground.

Is the measured voltage within specification?

	▶ Go to "Signal Circuit Inspection" Procedure.
	▶ Repair or replace as necessary and then, go to "Verification of Vehicle Repair" procedure

IG "OFF".

Disconnect APS connector and ECM connector.

Measure resistance between APS2 signal terminal of APS harness connector and chassis ground.(Measurement "A")

Measure resistance between APS2 signal and APS1(2) ground terminals of APS harness connector.(Measurement "B")

Is the measured resistance within specification ?

	▶ Go to "Check open in harness" as follows.
	▶ Repair short to ground in harness and go to "Verification of Vehicle Repair" procedure.

IG "OFF" and disconnect APS connector and ECM connector.

Measure resistance between APS2 signal terminal of APS harness connector and APS2 signal terminal of ECM harness connector.

Is the measured resistance within specification?

	▶ Go to "Component Inspection" procedure.
	▶ Repair or replace as necessary and then, go to "Verification of Vehicle Repair" procedure