Connect GDS to Data Link Connector(DLC).

Ignition "ON" & Engine "ON".

Select "Current Data" mode and monitor "Input speed sensor(PG-A)" parameter.

Driving above 20 Km/h.

Fig 1) "P,N" range

Fig 2) "R" range

Fig 3) "D" range 1st gear

Fig 4) "D Range 1st" grar,VEHICLE SPEED=0

Fig 5) "D" range 2nd gear

Fig 6) "D" range 3rd gear

Fig 7) "D" range 4th gear

Fig 8) "D" range 5th gear

Fig 9) "D" range 6th gear

Is measured "Input speed sensor" value within specification?

	▶ Fault is intermittent caused by poor contact between TCM and Sensor, and DTC was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair as necessary and go to "Verification Vehicle Repair" procedure.
	▶ Go to "Terminal and Connector Inspection" procedure.