Monitor GDS Data
1.

Ignition "OFF", connect GDS.

2.

Ignition "ON"& Engine "OFF", select "Diagnostic Trouble Codes(DTC)" mode.

3.

Monitor diagnostic trouble code and present of trouble code.

4.

Using a GDS , clear the DTC.

5.

Is DTC present problem ?

▶ In the option vehicles which is not equipped with Curtain and Side airbag,

If a side collision occurs over specific impact values, this DTC is set.

If you could not clear the DTC, replace a new SRSCM, and then go to "Verification of Vehicle Repair"

▶ Displaying nothing(no DTC) or DTC with label "H"(historical) shows that Fault is intermittent caused by poor contact in the part's and/or SRSCM connector or was repaired and SRSCM memory was not cleared.

Thoroughly check release pin and connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика