3.
Check input, output value and status of ISG system. (TPS, ECTS, RPM, Clutch S/W, Door S/W etc. )
Connect GDS to Data Link Connector(DLC).
Engine start.
Check input, output value and status of ISG system. (TPS, ECTS, RPM, Clutch S/W, Door S/W etc. )
Are the parameters displayed correctly?
 | ▶ Fault is intermittent caused by poor contact in the sensor’s and/or PCM/ECM’s connector or was repaired and PCM/ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, orrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure. |
 | ▶ Go to "Terminal & Connector Inspection" procedure. |
